Essmo™ Snake Skin Heat Transfer Vinyl HTV T-Shirt 20" Iron On Heat Press SP24 20"x120"

<p>Material Specification:</p><ul><li>PET Composition</li><li>Thickness:145 Microns / 5.7 Mils (Please make sure plotter is capable of cutting such thickness)</li><li>Heat pressure sensitive backing</li><li>Special Design Finish</li></ul><p>Application Instruction (Home Iron)</p><ul><li>Set iron dial between Cotton and Linen</li><li>Cover design with Kraft paper or non-stick cover sheet</li><li>Place on flat, hard surface (ironing board not recommended)</li><li>Press iron with medium/firm pressure (do not slide iron)</li><li>Press each section of design for 10-15 seconds</li><li>If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds</li><li>let it cool for about 30-45 seconds;and then gently peel back the clear plastic until it is completely removed.</li></ul><p>Application Instructions (Heat Press)</p><ul><li>Cut in reverse</li><li>Weed excess material</li><li>Preheat all fabric prior to pressing for best results</li><li>Apply design at 305;F/150;C;for 10-15 seconds</li><li>let it cool for about 30-45 seconds;and then gently peel back the clear plastic until it is completely removed.</li></ul><p>Applies to:</p><ul><li>100% Cotton</li><li>Poly / Cotton Blends</li><li>100% Polyester</li><li>Leather</li></ul><p>Laundering:</p><ul><li>Wait 24 hours before 1st wash</li><li>Machine wash warm or cold / mild detergent</li><li>Dry on normal dryer setting</li><li>Do not bleach or dry clean</li></ul><p>Note: Material will be rolled for shipment. Due to the nature of the material, wrinkles might appear after unroll. In this case, peel off the transfer tape (clear film) and re-apply transfer tape onto the film with heavy flat item on top such as yellow page for 15 minutes, the film will be back to the flat shape.</p>